Dks keypad manual

DoorKing DKS Internet - Modem Server SECTION 3 - PROGRAMMING General Programming Information Programming from a PC Programming from the Telephone Entry System Keypad System Memory Chip Identification Setup Telephone Entry System for PC Programming Master Code Number of Area Codes Allowed. Doorking Replacement. Mount the keypad out of the path of the moving garage door, but within sight of it (4" clearance is needed for the cover.) CHANGING YOUR 4-DIGIT PIN Enter existing PIN, press *, enter new PIN and press *. To test and use, enter your new PIN and press the 0 key. TYPE 1 Programming: Proceed with instructions according to your garage door opener type.

Doorking DKS 10 Memory Digital Keypad Programmable Surface. The DKS series family of keypads provides access control for virtually any application where digital code entry is desired and they are available for stand-alone applications or for connection to an access controller. minimum of ma for the keypad, and 20ma for each LED or night-lite. (-) negative VDC supply voltage input. wires are normally closed (N.C.) and wires are the normally open (N.O.) set of Main Relay contacts. The Main Relay is rated for 5 amps at 30 VDC. If you use this product to operate a DC door strike, magnetic lock, relay, or any. • Refer to Slave Keypad Instruction Sheet (p/n ) for instructions on mounting the board onto the circuit board. • Wire terminals on the board to terminals on the slave keypad. Pay careful attention to the terminal numbers as they can appear backwards (numbered right to.

Doorking DKS 10 Memory Digital Keypad Programmable Surface. The DKS series family of keypads provides access control for virtually any application where digital code entry is desired and they are available for stand-alone applications or for connection to an access controller. NOTE: Models , , , , , will have a supplemental manual (P/N ) that describes the operation and setup of the. access any of the programming functions of the digital keypad. 1. Open the cabinet and locate the Master Code button on the circuit board. 2. Press the Master Code push button once. 3. Enter a four-digit code _ _ _ _ on the keypad and then press * (short beep). 4. Close the cabinet. Relay Strike Time.