Innovate lc-1 manual

 · Ok I am confused. I recently ordered the LC-1 WB from amazon and they sent me the LC So I went back and looked on Innovate Motorsports' website and it says it has been replaced by the LC Now my question is has anyone used this and does it hook up the same way or do I .  · Innovate LC-1 reading incorrectly. Installed my Innovate LC-1 Wideband today with no issues. Everything went fine until I plugged my laptop in and fired up TunerStudio. The reading was different to my gauge, so of course I went to Calibrate AFR Table and selected "Innovate LC-1 Default". The problem is the TunerStudio Dash Gauge just hovers. 1 Overview The LC-1 is a stand-alone Wideband Controller used to measure the Air/Fuel Ratio (AFR) or Lambda for an engine. For gasoline-driven engines, the theoretically optimal air fuel ratio is pounds of air for every pound of fuel. At this ratio, theoretically, .

Carpentersville, IL. . #1. All, for those of you using LC1 wideband sensors, I just upgraded to the "beta" firmware version, and it really seemed to improve the accuracy and stability of the readings I get from the LC1 during operation. This may be old news, but I just finally did it and am happy with the result. It doesn't much matter what the Innovate manual says. What matters is that you load up the Innovate calibration software and look at what the LC-1 is actually outputting on each of the brown and yellow wires. 3" exhaust turbo back LC-1 o2 sensor Hallman manual boost controller EDIS 6 ignition batch fire 60mm throttle body 5 spd T5 borg. Well you would not pick Innovate lc-1 default because that is the 0 - 5v brown wire default. Yellow is narrow band sim. This manual has instructions on how to program the output 1 yellow wire to have the same settings as the brown wire.

LC-1 Installation Tutorial 1. LC-1 Install Description This Tutorial will provide general instructions for the installation, programming and integration of the Innovate LC-1 with EFILive Scan Tools and a DynoTune Display. Please refer to manufacturer’s manuals for details, warnings, and other specific information. Document # LC-1_Manual_doc LC-1 Digital Air/Fuel Ratio (Lambda) Sensor Controller Manual Warning! The Oxygen Sensor used in this device gets very hot in operation. Do not touch the hot sensor. Do not let a hot sensor touch a combustible surface. Do not use the sensor with or near flammable liquids or gases. 1 Overview The LC-1 is a stand-alone Wideband Controller used to measure the Air/Fuel Ratio (AFR) or Lambda for an engine. For gasoline-driven engines, the theoretically optimal air fuel ratio is pounds of air for every pound of fuel. At this ratio, theoretically, all available oxygen in the air combines with all available fuel.